Subject: Variable intake timing and P-port throttle.
From: ACRE
Date: 2/27/2005, 10:48 AM


Ben Baltrusaitis wrote:

Paul, would it make a difference if you turned the slide throttle 90 degrees to operate them vertically? I'm looking at putting them on a 20B and if there is a concern of frictional force on the 13B
setup, a vertical orientation may work better on mine.
Also, when cruising at partial throttle, would it be better to have the throttle opening across the rotor surface rather than only on one side?
Thanks!
Ben--

Not as far as frictional forces are concerned. They are caused by the high pressure
differences from  one side of the slide to the other. On a three rotor
you might want to build the ball bearing style as first shown as
the forces can be up to 140 pounds.

As far as your second question people rarely cruise at partial throttle.
What happens is people climb to 8000 feet or above  where the engine runs
at 80% power or below with the throttle wide open. This may not apply
to turbo charged engines however.

A few years ago Ken Powell came up with this idea. It was an attempt
to combine the throttle function with intake port timing change.
Having realized that most people cruise over 8000 feet WOT we never
installed it on an engine. I will upload the drawings and pictures in the
next message on this subject.

Paul Lamar

Here are some of the dwgs and pictures.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.