Subject: up and over P-port
From: ACRE
Date: 3/8/2005, 9:49 PM


This is two inch OD .065 wall 3 inch centerline radius
tubing from Burns Stainless. Looks pretty good as far
as cowl clearance is concerned. With slide throttle we are
hoping for 250 to 300 HP at 7500 RPM.

Paul Lamar

-- Jerry Hey wrote:

I found the 3 inch centerline radius tube to be too high over the
engine.     Jerry

Might be true for a Tail Wind with a 2.17:1 PSRU and long intake tubes. 
This is set up so the tubes can be tilted forward or back to lower them 
right down below the top of the rotor housing.

Here is one possible configuration since we are using a 2.85:1 PSRU
the tubes can be rather short.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.