Subject: E-shaft flywheel nut thread damage
From: ACRE
Date: 3/15/2005, 10:20 AM

jbeazley wrote:

Hello All;

I just noticed some thread damage on the e-shaft under tape on an
otherwise good e-shaft.
I did not remove it but it appears to have been crossthreaded
and pulled at some point.

I was thinking of cleaning it up.  The outermost thread is a mess and
the next peaks in slightly flattened.

The threading appears to be 16 threads per inch or more likely 1.5mm?
I can do this cleanly on a lathe.

Is it worth fixing or should I look for another e-shaft?
Does the flywheel nut engage the e-shaft threads fully when installed?
How much taper?
60 degree threads?

Thanks
Cary

Tough Call. I have no idea what just an e-shaft is going for these days.
Santa Paula pick a part junk yard has two 88 to 91 13Bs for $350. One has the intake 
manifold removed with the hood open so the end housings and rotors are probably rusted. 
You might pick up that engine for near zero. The other might be OK.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.