Subject: E-shaft flywheel nut thread damage
From: ACRE
Date: 3/15/2005, 2:31 PM


jbjbeazleyrote:

Hello All;

I just noticed some thread damage on the e-shaft
under tape on an
otherwise good e-shaft.
I did not remove it but it appears to have been
crcrossthreaded> > and pulled at some point.

I was thinking of cleaning it up.  The outermost
thread is a mess and
the next peaks in slightly flattened.

The threading appears to be 16 threads per inch or
more likely 1.5mm?
I can do this cleanly on a lathe.

Is it worth fixing or should I look for another
e-shaft?
Does the flywheel nut engage the e-shaft threads
fully when installed?
How much taper?
60 degree threads?

Thanks
Cary

Tough Call. I have no idea what just an e-shaft is
going for these days.
Santa Paula pick a part junk yard has two 88 to 91
13BsBsor $350. One has the intake
manifold removed with the hood open so the end
housings and rotors are probably rusted.
You might pick up that engine for near zero. The
other might be OK.

Paul Lamar


Cary

eBeBays your friend when it comes to things like this.

See,
hthttp/cgcgibebayom/ebebaymotorsswsBeBayISAPIldlliViewItemd=1&item=7960773338

Erik

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.