Subject: Japan trip lost pictures found.
From: ACRE
Date: 3/18/2005, 9:47 PM


First pic is me with some of the Mazda Execs. taken in the executive
dining room.
The guy to my immediate left is the RX8 project manager Noboru
Katabuchi.

Smile and walk. Don't take the elevator and save juice. Also
get some exercise as it is good for you.

Start of tour in rotary engine factory.

Paul Lamar

Here are some pictures about the RX8 rotor casting technology.

Paul Lamar


Paul,
 I just got back from the local Mazda repairer and was looking for a 9.7:1
rotor for my single.
Strange as it may seem the RX8 rotor is half the price, lighter, better
balanced.
I think the compression ration is 10-1 is that correct?
As I have to make a single e-shaft from scratch and balance the new rig, I
am set on getting a RX8 rotor with 3mm apex seals.

It would appear the RX8 rotors are a little wider than the 13B rotor but
this can be modified.

The shorter side seals are to accommodate the extra heat growth of the side
seals due to the side exhaust port, but longer ones can be used.

Might be a consideration for those considering singles.
George ( down under)

Yes I think it is 10:1. Good for any NA engine. Not good if you turbo or super 
an RX8 engine.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.