Ken Welter wrote:
Alright now you got me thinking about doing it.
How are the tubes held in and sealed?? threaded in and orings or
what??
Do you have any specifics on the bore size in the housing and on the
tube??
Ken Welter
Epoxy. I am picking up some high temp stuff tomorrow.
I will then have the right part number and source.
A 1 3/4 shell mill is perfect for roughing out the housing.
I am using 2 inch tube with .065 wall. I.875 ID.
Paul Lamar
Paul,
Was there any flaking of the internal chrome coating?
How did you finish the inside - by hand ?
George ( down under)
That was a big unknown when we started this project. I was extremely pleased
to find out absolutely no flaking resulted when we used the final boring bar.
In fact it is a very sharp and clean edge. John, at Mazdatrix said, he will
chamfer the edge much like what is done by Mazda on the exhaust port.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.