The e-shaft pully... normal thread or revese thread? (before we put a big piece of pipe over the wrench) does this also require a gear puller to pop it off?
...Chrissi

www.CozyGirrrl.com
Cozy Mk-IV RG 13B-turbo
Plans #957 Chapter? big pieces done, details, details

Its a normal thread and you do need to take if off before the big nut
on the back. The flange/hub  slides right off. Are you disassembling the engine?
If not make sure you keep the shaft vertical or the thrust bearings can come
off their pilot. I would take the front cover off to make sure the thrust bearings
are assembled properly. Very tricky. Do you have the third gen shop manual?

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.