First pic is me with some of the Mazda Execs. taken in the executive
dining room.
The guy to my immediate left is the RX8 project manager Noboru
Katabuchi.
Smile and walk. Don't take the elevator and save juice. Also
get some exercise as it is good for you.
Start of tour in rotary engine factory.
Paul Lamar
Here are some pictures about the RX8 rotor casting technology.
Paul Lamar
More pictures. IMHO one of the very subtle reasons Mazda's apex seal system
works so much better than coated aluminum housings is the high modulas of
elasticity of the steel liner used. All materials act as a spring more or
less. The measure of the stiffness of a material is called modulas of elasticity.
The steel number is 30 million while that of aluminum is only 10 million.
My half baked theory is when the apex seal chatters it is bouncing up and down on
the wear surface. The higher the modulas of elasticity the higher the
frequency of this bouncing. There are plenty of other factors of course.
One of which is the friction between the apex seal and the wear surface.
Lower weight apex seals seem to work better. Early attempts by Mazda
was to drill out unneeded material in the apex seal to lighten it. The silicon nitride
ceramic seals have no problems at all because they weigh very little
and are super smooth. The down side is the $200 EACH cost. $1200 for the whole
2 rotor.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.