Works slick. I already found a few improvements I can make.
One, it will have fewer bolt holes and bolts.

The first pic is looking at it from the point of view of the engine.
The second pic shows the side connected to the bends with silicon

hose.

Paul Lamar

Sign me up for one.
Marc Wiese

Mark R Steitle wrote:

Paul,
Are you planning a 3-rotor version?

Mark S.
(fingers crossed)

An economic decision that is going to be up to the distributor.
You are free to copy the design but without a NC turret punch it is time consuming.
Only simple tools like a shear and drill press would be necessary to make
one on your own. A table saw might work a bit better than a shear if you
had a fine tooth carbide blade to cut aluminum. You will require the services
of a good tig welder.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.