tim tracey wrote:

Got all my parts from Racing Beat. Seems simple enough, but has
anyone

put out a build manual for

P-Ports yet? Don't want to take any chances, you know? Thanks!

No different than a side port except you need to fill the side ports
with
high temp epoxy potting compound. Are you using RB p-port rotor
housings?

Paul Lamar

George Lendich wrote:

Tim,
As was put to me by the experts some time ago, you can't really go
wrong
ALSO Paul and Jerry are manufacturing PP for distribution - takes all
the
fun out of it, I know!
George ( down under)

George and all,   Not until my p port's performance is established,
will I even consider making one for someone else.  Today I ordered the
injectors and the  K & N filter and made some little weld on  bushings
to transition from the 2" o.d. throttle bodies to the 1.9" o.d.
runners.  I hope to actually start putting the intake manifold together
this week end.  Seems like I have been looking forward to it forever.
It will have both filtered alternate air and ram air and bell mouth
injection.      Jerry

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net            
Copyright 1998-2005 All world wide rights reserved.