Subject: Dual turbo four rotor P-port rotary engine anyone?
From: ACRE
Date: 3/25/2005, 10:47 AM


     > One of these ought to really clean their clocks in
     > the Reno Sportsman class. Maybe even the Unlimiteds.
     >
     > Seen in Japanese magazine.
     > This uses the Mazda 3 rotor trick of a shaft inside of a shaft to build
     > a multi rotor engines using stock center housings. This is also a
     > testament to the excess strength of the stock Mazda rotary engine
     > shaft.
     >
     > Guru Racing Motor sport made this shaft I think.
     >
     > Paul Lamar

Kelly Troyer wrote:

       Paul,

          Do I have this right.......Five main bearings.........Center three would

     be roller bearings........End bearings would be stock sleeve bearings ??



      Kelly Troyer

Yes I think so. BTW when I was in England at Hurley engineering
I saw a six rotor version. Eamon looked at me kind of funny when I said
I thought it was a joke. Anybody can stack up a bunch of housings. 
Perhaps it really is possible. If it is IMHO
it is really pushing the torsional strength of the e-shaft.

Could be Emon invented this center main roller bearing way back
when and Guru Motorsports picked up on it. I also saw a three rotor in an RX7 
in England without the special three rotor intermediate housing. Stock 13B 
intermediate housings.  I asked Eamon if I could see the shaft and he told 
me he did not have one out of an engine.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net            
Copyright 1998-2005 All world wide rights reserved.