Subject: Here's the actual picture of the oil cooler
From: ACRE
Date: 3/28/2005, 3:30 AM


We will find out when you get your new cooler installed. Hopefully it
will work fine and the $900 will be money well spent.

Paul Lamar


 Thomas Parkes wrote:

Paul:

Yes, the original scoop was fabricated before I learned of the design
limitation of NACA scoops with heat exchangers.  When I enlarged the
scoop, as in the second photo, my oil temperatures went down about 10
degrees F, which helped.  But ambient outside air temperatures above
85
degrees F still restricted by climb performance by requiring a 140
KIAS
cruise climb in order to keep oil temperature below 220 degrees F.

I have redone the oil cooler scoop a third time, removing any vistages
of a NACA scoop.  Time and flight test will tell if it was worth it.
But that's the fun part.  Almost anybody can fly  a spam can.

Tom P.


Got any pictures of the new scoop and ducts Tom?

Paul Lamar

Thomas Parkes wrote:

Paul:

No photos of scoop or ducting yet.  Still in process as I fabricate
brackets for the new oil cooler.  It's slow going now that I'm working a
40 hr. week again.

Tom

I just realized another problem you may have been having.
You are pressuring the cowling to feed the rear mounted water rad.
That probably put back pressure on the oil rad.
Here is my suggested solution to that. Seal the back side of
the oil rad to the out side of the cowl and put some louvers
out there. Reverse the air flow through the oil rad.

Paul Lamar

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net            
Copyright 1998-2005 All world wide rights reserved.