Subject: Renesis RX8 rotor cost and casting
From: ACRE
Date: 4/5/2005, 11:58 PM


Robin Ream wrote:

   Anybody know what the going price for a new Renesis engine is, and how long the wait is?

Robin


Ian wrote:

i just priced a set of rotors for a S5 na $480/ea. as a set.. RX-8
rotors $280 ea as a set housings/rotors/end plates ALL similar in
pricing i don't imagine a long block being cheaper but you can build up
a short block for 1/2 the price of an S5 B/BT...  those crazy mazda
guys. Availability for the Renesis parts was immediate

Ian
BAS

I think it has to do with the way the RX8 rotors are cast. 
They are centrifugal cast from the center and they come out of the 
sand more or less in balance. According to Mazda there is no need to heat 
treat them where as early rotors were heat treated because of low density sections.
In other words the quality control of the material was better throughout the 
casting. Perhaps the yield of good castings was also higher. This probably 
saved money. Unfortunately I did not get to see 
the foundry when I was in Japan at the factory. They may have improved the
automation of the casting process also saving money.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net            
Copyright 1998-2005 All world wide rights reserved.