Thanks for catching that Chrissi. Did your DXF copy load correctly
    with circles?

    Chris Cosman  please rotate the small  pilot holes 90 degrees CCW.
    Make it look like the RX8 manual illustration shown below.

    Paul Lamar

it dxf'd in fine but was flat to the Y axis...in other words apeared as a single flat line
here i'll just send you the DWG file.

Well I saved it as a one dimensional single view 2D.

OK try these.

Chris please pass these on to Matt. I corrected the hole positions and one other
minor problem.

Paul Lamar

Okay, I've passed it along.

I'll have them cut one just to see the quality, take some pix, and post
them here.

Chris Cosman

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net            
Copyright 1998-2005 All world wide rights reserved.