Subject: Renesis RX8 rotor cost and casting
From: ACRE
Date: 4/6/2005, 8:08 PM


Robin Ream wrote:

  Anybody know what the going price for a new Renesis engine is, and how long the wait is?

Robin




Ian wrote:


i just priced a set of rotors for a S5 na $480/ea. as a set.. RX-8
rotors $280 ea as a set housings/rotors/end plates ALL similar in
pricing i don't imagine a long block being cheaper but you can build up
a short block for 1/2 the price of an S5 B/BT...  those crazy mazda
guys. Availability for the Renesis parts was immediate

Ian
BAS

I think it has to do with the way the RX8 rotors are cast.
They are centrifugal cast from the center and they come out of the
sand more or less in balance. According to Mazda there is no need to heat
treat them where as early rotors were heat treated because of low density sections.
In other words the quality control of the material was better throughout the
casting. Perhaps the yield of good castings was also higher. This probably
saved money. Unfortunately I did not get to see
the foundry when I was in Japan at the factory. They may have improved the
automation of the casting process also saving money.

Paul Lamar

Ian wrote:

 Is there enough material in the 'pocket' to take the compression down
to ~ 9:1 ? I've yet to read or hear of anyone doing this yet but it
would be nice to have the ability to use higher quality, lighter rotors
in a turbo motor as well..

Ian
BAS

Good question Ian. I don't think so. I sent email to my contact at Mazda six months 
ago suggesting they add material to the rotors in that area so those that wanted to turbo charge 
could mill out the pockets.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net            
Copyright 1998-2005 All world wide rights reserved.