Subject: P-port engine rebuild starts off on a bad note...
From: ACRE
Date: 4/19/2005, 12:22 PM

tim tracey wrote:

My 13B Turbo II core engine that is to become a 9000RPM, 300HP PP has decided it's not giving up
it's old life without a fight. The old 13B flywheel nut that I had to experiment on before gave up
without so much as a whimper, but......this beloved flywheel nut has resisted lubrication, my 2
1/8" nut, it's 3/4" drive 4' breaker bar, my full weight on said bar, and numerous hits with both
a rubber mallet and a 4lb maul on the end of said breaker bar...I'm desperate...I have no impact
wrench....any suggestions? Thanks!!!!

It takes a six foot breaker bar Tim or a 3/4 drive impact wrench.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net            
Copyright 1998-2005 All world wide rights reserved.