Gary Gustafson wrote:

Hello Paul

I am the fellow in the wheelchair and I enjoyed talking to you.

I would like to be put on the rotary newsletter list.

I will send you pictures of the Murphy Elite Mazda installation cooling
system

that I mentioned at Sun n'Fun when I get them. In the meantime I have the

following pictures with the top cowling off, so the next three emails each

will contain one picture. Any comments that you have regarding these

pictures would be welcomed.

It has been sitting for a while.
Not sure where the aluminum duct work in the foreground goes to - oil cooler
or radiator?

Note the helmet cap in place of a spinner. My guess is that the entire area
around the prop

Shaft is need for cooling. There does no appear to be a scoop underneath the
prop (or no

picture that I currently have indicates that there is one)

Note the helmet cap in place of a spinner. My guess is that the entire area
around the prop

Shaft is need for cooling. There does no appear to be a scoop underneath the
prop (or no

picture that I currently have indicates that there is one)



Gary Gustafson

Tequesta, Florida

Gary, the scull-cap spinner is standard for the Ivo prop. You should not
have a spinner to cover the whole base of the prop. There are special tape
strips to monitor for any play in the blades. You can see them in the photo
bridging the two blades
Bulent

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net            
Copyright 1998-2005 All world wide rights reserved.