Right, ummm, Gunny...LOL! Any suggestions as to the alternator? I've already got the '83
distributor with it's twin igniters as per RB. Also, should I go ahead and replace the water pump?
I've got the smaller pulley from RB, and the existing pump seems good to go, but......
Another question.....anybody know of a auto-equivilent for the 1/4" Parker plastic brake tubing
that Matco sends out with their units? I've got enough to plumb the pedals to the external
reservoirs(job done), but I need something on the order of 16' for the twin lines going back to my
main Matco brakes. Yea, I know I can order more from them, but I'd like a auto/other source, too
if possible.
AW POO_DOO.....almost forgot.....I've gotta use the light flywheel from a manually-transed 13B
circa 1985 due to the PSRU, but RB is hinting that I may need to balance the PP by using the
counterweight(which I have)from that old engine, too, instead of the existing one that seems to be
matched for the thicker flywheel(which I'm not going to use)on this engine????
Thanks!!!
I would not use plastic brake line. I would use -4 or -6 double braided
AN brake line as used on racing cars. Not worth risking your airplane.
Why the 83 distributor? Why not use the RX8 e-shaft trigger wheel?
Which computer are you using?
Why the flywheel instead of the auto tx flex plate?
Which PSRU? Just curious.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.