Subject: P-port engine rebuild starts off on a bad note..
From: ACRE
Date: 4/20/2005, 7:04 AM


<< Thanks for the scoop, Lynn, but I got it off the Marine Corps way.......no
not a .50BMG at
 > point-blank range...LOL! I ended up taking a thin wedge of aluminum, and
using my 4lb maul, struck
 > the nut's flats back and forth, then reapplying the breaker bar and
extension; the nut gave up the
 > ghost without damaging anything! Then, by doing a similar trick to the
flywheel, it too came loose
 > without a fight. Today, I got the rebuild kit for my 13B/4-port-to-P-Port
conversion....I begin
 > tomorrow.....wish me luck!

In other words,

The nut and the flywheel had not been trained up to the current standard, and
once the senior Sgt. leaned in real close with the correct training aids, the
trainees were able to perform as expected.

Don't forget to replace the affected thrust parts.

Semper Fi.

Lynn E. Hanover


 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net            
Copyright 1998-2005 All world wide rights reserved.