Subject: P-port engine rebuild starts off on a bad note...
From: ACRE
Date: 4/20/2005, 7:04 AM


tim tracey wrote:

My 13B Turbo II core engine that is to become a 9000RPM, 300HP PP has
decided it's not giving up
it's old life without a fight. The old 13B flywheel nut that I had to
experiment on before gave up
without so much as a whimper, but......this beloved flywheel nut has
resisted lubrication, my 2
1/8" nut, it's 3/4" drive 4' breaker bar, my full weight on said bar, and
numerous hits with both
a rubber mallet and a 4lb maul on the end of said breaker bar...I'm
desperate...I have no impact
wrench....any suggestions? Thanks!!!!


It takes a six foot breaker bar Tim or a 3/4 drive impact wrench.

Paul Lamar

One other option, is if you take it to your local Truck tire repair center,
such as Firestone. They have the big 1 inch impact wrenches, and can spin
that nut off for you in a few seconds. Probably talking only a few dollars.
Our local Firestone dealer uses a 1 inch impact wrench to remove our
tractor-trailer tires.   Paul Conner

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net            
Copyright 1998-2005 All world wide rights reserved.