Subject: cooling improvements
From: ACRE
Date: 4/24/2005, 11:24 PM

Paul wrote:

Hi, Paul....because I sent 6 pictures, I wanted to explain this one in particular. This was taken looking directly into the duct towards the radiator. At the top right, you can see the approximately
3/8 ridge extending down into the duct, which is the bottom of the firewall (cutout for the NACA duct). On the left side, you can see how much material was removed just to make it flush. I then made
a radius at that corner. (top of duct to firewall). As you can see, that was a lot of material sticking into the duct.  The round item in the center is my aileron control rod. Of course I also
removed the remaining material and made the radius to the opposite side after taking the picture.  Hope this better explains the picture.  Paul Conner

Don't get your hopes up too high on this problem solved :)

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net            
Copyright 1998-2005 All world wide rights reserved.