Ben Baltrusaitis wrote:
Paul and everyone,
I need some help with cooling a Kitfox 5 with an EJ-22 Subaru. I
bought this plane so I have something to fly while my Acroduster Too
w/20B is under construction.
My problem is that on climbout it is running hot. (Cruise is no
problem.)This is due to the fact that the air is flowing over the
muffler and then through the radiator.
I need a simple cheap fix. I would rather not redo the whole cowl
and radiator position as I will probably sell this plane after my
Acroduster is flying. However, if I must I will.
I have thought about ducting the muffler to dump air in front of
the radiator, keeping the flow out of the radiator. I don't know if
that will destroy the air flowing from radiator exit.
Another problem area, there is also little clearance under the
radiator for a good flow out. I know from your recommendations
that the clearance is tight. If you tell me I must move the
radiator, I will, but would rather not. I think this engine could
be cooled with a smaller radiator if it was properly setup. The
radiator size was doubled after it was test flown.
Thanks! Your ideas will be most appreciated!
I'm certain you'll get a number of ideas on ducting air to the radiator
(from Paul if no one else). Before you get too involved with those
changes, you might consider applying some insulation to the exhaust
manifold, down pipes, and muffler. Perhaps some ceramic fiber mat cut,
wrapped, and secured with safety wire.
http://www.infraredheaters.com/insulati.htm
This would prevent the hot elements from radiating heat onto the
radiator face and conducting heat to the under cowl air. It is
straightforward to implement, and doesn't modify the cowl or cowl
openings, which is good if your cooling changes don't work out (easy to
"undo").
Russell Kent
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.