Doug wrote:
Hi All,
I would like to kind of get an idea of how many people need a lower
manifold for their Renesis motor. I know the trend is toward P port but
there will be a few that would like to keep the standard bolt on type
for simplicity. Could you please respond. I have been talking to Paul
about vending these things and if there is enough interest we can do a
batch. Thanks
Doug Mueller'
RX6 13BT
N900DM
Boulder City, NV
Doug
Have you had a close look at the stock Renesis manifold? I have one and it
looks like it would be simple job to cut off the top 2/3rds leaving the part
with the fuel rail and injectors. Then welding on four 90 degree bends and
two 135 degree bends ,(6 ports). Also it might be possible to connect 4 of
the pipes for pulse charging, the same as stock. Question is, are ally
bends 30mm inside diameter available?
Ian Beadle. W. Australia.
I guess my question is answered.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.