Subject: Lower Manifolds for the Renesis
From: Rotary Engine
Date: 5/3/2005, 7:52 AM
To: AA-me

Doug wrote:

Hi All,
I would like to kind of get an idea of how many people need a lower
manifold for their Renesis motor. I know the trend is toward P port but
there will be a few that would like to keep the standard bolt on type
for simplicity. Could you please respond. I have been talking to Paul
about vending these things and if there is enough interest we can do a
batch. Thanks
Doug Mueller'
RX6 13BT
N900DM
Boulder City, NV

Using part of the stock manifold looks OK. See pics.  If there is enough
clearance under the James cowl we will be able to use the fuel rail and
injectors as well.

Just need six  90 degree 30mm bends.

For Ben Schneider. Could you measure the clearance from the top of the
engine to the cowl for me please.

Ian Beadle

No doubt this will work OK.
Not to belittle this idea but it needs to be pointed out that it will
not generate as much power as a p-port for at least one
reason.

A 30 mm tube is about 1.2 inches in diameter. For every inch of
length it has an inside surface area of about 3.1416 square inches.

Since there are six the total inside surface area is 18.84 square
inches. With a P-port using two, 2 inch diameter tubes the
surface area is 5.89 square inches per tube per inch or 11.78 square

inches total. Air velocity in the intake manifold is around mach
.4 so this makes quite a bit of difference in terms of pressure
loss due to skin friction drag in the runners. This is one reason a
p-port engine generates so much more power over 5000 RPM.
The Lemans engine P-port in two rotor form generated about
345 HP at 8500 RPM or about 300 HP at 7500 RPM.

Also the pumping losses are lower so the BSFC or fuel burn
should be lower at 5000 RPM and above. My RX8 engine seems to
get much better MPG at 3000 RPM or below. Possibly because of this reason.

The RX8 engine will generate 240 HP at 8500 RPM and about
212 HP at 7500 RPM roughly. Mazda uses these small runners for several
reasons. Mainly to fill the chambers better at 2000 RPM
where the very small displacement rotary engine needs a lot of help in
the torque department. My RX8 engine pulls well in sixth gear at 2000
RPM and 40 MPH. Since we don't need torque at 2000 RPM for aircraft use
a P-port IMHO would be a better choice. The fixed pitch prop does not
start loading the aircraft engine until about 5000.

Paul Lamar


-- 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.