BTW Jerry check those injectors you have and make sure they are good for over 200 HP.
The stock Mazda NA injectors are probably limited to 175 to 200 HP somewhere
in there. The turbo injectors are probably good for somewhat more but
I am not sure how much. Also the fuel pump and fuel plumbing should
be increased in size.  I am using AN -6 for fuel plumbing.
This is the main reason I am going to MSD injectors because I know
how much fuel they can flow.

Paul Lamar

Paul,  I, too, am going to  use -6 for fuel lines.  The injectors are
Ford 42's.  I ran the on line formulas for injector sizing and these
seemed to be able to do the job.   Jerry


Do you have the web site address?
It would be a help for a lot of people doing higher power
engines.

Paul Lamar

The six port Renesis uses 2 very fine spray secondary injectors per rotor,
one each side. I sure hope Tracy's engine computer can handle the extra one,
or its back to the Michrotech.

Ian Beadle