Rotary Engine wrote:
>>
>> Since the P-Port will soon be returning to us, I've begun the final
>> round of parts ordering to turn this all into an airplane.
>>
>> One area we still need some advice on is what type of prop to be
looking
>> at. We are looking at fixed-pitch for right now. Although we may at
>> some point in the future reconsider CS, the simplicity of fixed pitch
>> seems the right way to go while we work out all the kinks in the M2 and
>> in the FWF.
>>
>> Personally, I am leaning toward a wood prop. But I'm unclear on how
the
>> (potentially) high HP of the engine plays into this. And the idea of a
>> ground-adjustable props has some attraction as well.
>>
>> Does anyone have some experience in this area they can share with us?
>>
>> Mark & Mark
>> -
>>
>> I think Vance might be able to help you. He has a prop program.
>> Vance what say you for a Mustang II with about 250 HP.
>>
>> Paul Lamar
>>
>
> I can plug it into my program and get a pretty close size, Need at
> least a
> couple
> of HP points at prop shaft rpm - What max dia can you comfortably clear
> and how would you rate the plane - ie "clean" average? well faired gear"
> tri or tail dragger? - Vance
>
>
The airplane is a Mustang II (2-seater), not a Midget Mustang
(1-seater). It is a tailwheel. It has the minimum fairing, so I
suppose it would be at best average, maybe even dirty. Typical prop
diameter is 70". Some guys swing 74", but that's a little aggressive
for me.
Thanks,
Mark & Mark
Guys - I still need to know what propshaft rpm do you plan on supplying that
250hp?
The full throttle sea level design speed for the airframe as described is
probably
about 210 mph, and the prop would be pitched for about Cl of 0.4 at that
point. and the width
distribution of the blades set to use the stated hp at that point. The shape
of the power
curve back down on rpm will establish the predicted static rpm and power.
The shape of the power
curves for conversions (even Wankels) is usually "fatter" than that for an
"aircraft" engine
usually providing better static and climb power for the same "rated power".
Conts and
Lycs are rated usually just at or before the torque peak making a virtually
straight line.
Conversions are usually "rated" at peak horsepower - usually well past the
torque peak,
"fattening" the curve.
Vance
7500 engine RPM gives a 2630 prop RPM with a 2.85:1 PSRU ratio.
We are hoping for 250 HP at 7500 engine RPM.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.