> Anybody using an AN fitting fuel pressure regulator?
> If so what are your experiences so far?
>
> Paul Lamar
Hi, Paul....I am using a TWM adjustable fuel pressure regulator. It has a
male O-ring boss fitting on one end that screws into the fuel rail, and the
other end has a male AN fitting, to which I simply attached a stainless
steel braided fuel line with a female AN fitting. It is the red and blue
item on the right hand (forward) end of the fuel rail. I can take a better
picture of it if you wish. Paul Conner
Thanks Paul. Do you remember what it cost?
Paul Lamar
I've got the stock fuel rails and regulator. Is there a problem with
using these?
Brian Trubee
It will work Brian. Just not up to aircraft standards of reliability
and durability like AN plumbing. There is another factor. When
your average pilot looks at your engine he is turned off if it
does not have AN plumbing. I am willing to bet if we did a survey
people would pay a lot more for an experimental aircraft
with a rotary engine if it had all AN plumbing. In that case
it would look like an aircraft engine and not a car engine.
Paul Lamar
Not discounting the value of aircraft hardware, but the lines and
fittings will be covered with fire sleeve. Getting the installation to
look clean and proper is one of my goals.
Brian Trubee
Firesleve is good however it adds to the inspection
problem. I prefer double braided stainless hose and Teflon liners.
Very fire resistant.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.