Firesleve is good however it adds to the inspection
problem. I prefer double braided stainless hose and Teflon liners. Very
fire resistant.
Paul Lamar
Ah yes... Stainless braid hose. AKA motormount tubing cutter..
Just kidding. I like it too, but you have to be double careful about
chafe protection.
MAP
I used stainless steel braided lines for my fuel lines up to the fuel rail
and back to the sump tank. The steel does, however absorb a lot of heat, and
I believe that was one of the primary contributors to my engine-out
vaporlock landing. I installed firesleeve over the stainless steel braided
lines, (along with a couple of other mods) and was unable to get the engine
to falter from high temps after the firesleeve. Paul Conner, Mobile, AL
Good tip Paul thanks. Best to route the lines far from the
exhaust system.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.