Subject: Four injector fuel rail for P-port engine.
From: Rotary Engine
Date: 5/13/2005, 9:32 PM
To: AA-me

This is easy to make and can be done on a drill
press. All you need is the right tools.

A real long 1/2 inch drill.

A 17/32 drill for the injector holes.

A 3/4 60 degree counter sink. Same one used
on the injector holders.

A 9/16 18 tap for the AN -8 fittings.

It took me less time to make this than it did for me to
make this 3D by a factor of 3.

The first couple I made were out of 3/4" by 1" 6061 T6 bar stock
but they were not entirely satisfactory. Best to use 3/4" by 1-1/4"
obtained by mail order from Industrial Metal Supply in San Fernando
Calif.

Paul Lamar

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.