Subject: New dual injector holders for P-port engine
From: Rotary Engine
Date: 5/13/2005, 10:29 AM
To: AA-me

I just did this one over for the third or fourth time.
It is kind of tricky. The problem is the injectors
are built with metric dimensions and that vast majority
of cutting tools available here in the states are in inches.
As are the vast majority of machine tool holders.

Standard practice for inserting
an O ring in a bore is a 20 degree entrance angle
so I bought a 40 degree V shaped end mill. WRONG!!
Could not get the silly thing to stop chattering no matter
how slow I ran the mill. I had to compromise and buy
a 60 degree 3/4 inch counter sink. You must be very carefully with
this as the MSD injector design leaves little room for error.
Too deep and the O ring will not have room on the bore to
seal. Too shallow and it is near impossible to get the O-ring
in the bore. I compromised by using a 60 degree counter sink.
That works.

The trick is having the right tools. It is also much harder
to do with a cheap Chinese mill. Easier to do with a knee mill
as you can compensate for different cutting tool lengths
by running the knee up and down. If you don't have a knee
mill, tool lengths become a large issue as you don't want
to recenter the work over and over again. Concentricity is
extremely  important. I got so frustrated
on this issue I nearly went out and bought a new knee mill.

This requires a 17/32 drill about eight inches long.
Preferably with a 1/2 inch shank.
Mill chucks are not accurate enough in my experience.

a 3/4 60 degree (30 degree each side) counter sink
also with a 1/2 inch shank.

A boring head to do the large bore that supports the
injector body.

It is time consuming to make by hand but an NC
mill with tool changer and the proper cutting tools
could do these lickity split.

It could also be done easier with a custom cutting tool.
MSD has one but it does not fit this series of injectors.

I'll do a drawing with dimensions if anyone is interested.

http://www.msdignition.com/fuel_4.htm

Paul Lamar

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.