Subject: Murphy Elite with a 13B powerplant
From: Rotary Engine
Date: 5/14/2005, 1:20 PM
To: AA-me



Hello Paul

     I have recently purchased a Murphy Elite with a 13B powerplant built by Daryl
Drummond. Kit is complete but has not been flown.I would like to join the newsletter.

                       Thanks for your time
                        Geir Andersen


You got a bargain there Geir. I am fairly  familiar with the history
of that airplane as it was built in my neck of the woods.

I suspect the engine cooling was/is an issue and that is why it was not flown.
Not to worry! Easy to fix! I don't have pictures of the engine
compartment with the lower cowl off so please do so and take
some pictures with a digital camera or a regular camera and scan
them in or just mail them to me and I can scan them in.

Here are a few I have already.

When you get this flying you will love the rotary engine.

Paul Lamar

Geir, Here is a way to get flying in a few days.

Since the Murphy has a limited amount of room under the engine
this is a very fast way to get the cooling working.
No need to make make major changes in the cowl. You can probably leave
the oil cooler where it is with minor changes to the internal
ducting. This has been successfully used on Rans airplanes for years.
You can change the angle of the rad to increase or decrease
the cooling. Just about any 16 by 20 inch rad will work fine.
The yellow plate is a boundary layer air splitter.

One side plate is not shown in the side view.

Use blue silicone rubber hose and Breeze constant torque
hose clamps for reliability. We have had two airplanes crash
so far because they blew off auto quality ( or the lack of it)
water hoses.

Paul Lamar

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.