Subject: Murphy Elite with a 13B powerplant
From: Rotary Engine
Date: 5/15/2005, 7:32 AM
To: AA-me

Scroll down to read the latest message in this thread.


Hello Paul

       I have recently purchased a Murphy Elite with a 13B power plant built by Daryl
Drummond. Kit is complete but has not been flown.I would like to join the newsletter.

                         Thanks for your time
                          Geir Andersen


You got a bargain there Geir. I am fairly  familiar with the history
of that airplane as it was built in my neck of the woods.

I suspect the engine cooling was/is an issue and that is why it was not flown.
Not to worry! Easy to fix! I don't have pictures of the engine
compartment with the lower cowl off so please do so and take
some pictures with a digital camera or a regular camera and scan
them in or just mail them to me and I can scan them in.

Here are a few I have already.

When you get this flying you will love the rotary engine.

Paul Lamar

Geir, Here is a way to get flying in a few days.

Since the Murphy has a limited amount of room under the engine
this is a very fast way to get the cooling working.
No need to make make major changes in the cowl. You can probably leave
the oil cooler where it is with minor changes to the internal
ducting. This has been successfully used on Rans airplanes for years.
You can change the angle of the rad to increase or decrease
the cooling. Just about any 16 by 20 inch rad will work fine.
The yellow plate is a boundary layer air splitter.

One side plate is not shown in the side view.

Use blue silicone rubber hose and Breeze constant torque
hose clamps for reliability. We have had two airplanes crash
so far because they blew off auto quality ( or the lack of it)
water hoses.

Paul Lamar

Hi Geir,

I thought of a couple of things you also need to do.

A: Disassemble that Ross gear box and check it for proper
machining. Late Ross gear boxes were notorious for bad quality
control.

B: Also check it for the existence of a sun gear thrust bearing.
If it does not have one it will eventually destroy the thrust
bearing in the engine. It is relatively cheap to add one and
much safer in the long run. If you are not sure what that is
take some pictures of the parts and upload them here.

Where do you live? We may have somebody in the neighborhood that
has experience in these matters and that can help.


C: Read the article on the web site below called "How To Cool Your
Wankel". It is in TECHNICAL TOPICS IN ALPHABETICAL ORDER
 > COOLING > How To Cool Your Wankel


Paul Lamar


The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.





Tracy-Psru-neele-thrust-bear2.jpg

SCOTT_SPEIRER_ROSS_BELL_SUN.JPG

SCOTT_SPEIRER_ROSS_SUN.JPG