Subject: Murphy Elite with a 13B powerplant
From: Rotary Engine
Date: 5/15/2005, 8:20 PM
To: AA-me



Howdy Paul

      Thanks for the quick reply. I live in Arlington , Wash. The Elite is currently at my home but after working some bugs out I will be moving it to my hanger at Arlington airport.I have a few issues to resolve prior to the move and reassembly.

1. I have concerns about the injector to fuel rail connection. I failed to open the fuel return tank valve and upon turning on the fuel pump I blew the o-ring at the supply side of the injector. There was enough pressure that the fuel rail actually flexed the mount to the intake plenum and popped the o-ring and I had quite a fuel leak. I am thankful to have seen this prior to flite.  There is an alignment issue that is an easy fix and some stiffening necessary but I was trying to locate a more positive fuel rail connection and so far have not had any luck.

2.Sent EC2 back to R.W.S., as the pcm was not functioning.I just reinstalled and tested and all appears ok.

3.I started the engine and prior to start the engine back fired and cracked the weld on the intake plenum .I`m not sure if i have a CAS timing issue or if the ec2 may be at fault. After a temp. ductape patch I started the engine and all seamed ok.

5. After a 3-4 minute run I shut the fuel pump off and accidentally hit the master switch. I turned the master back on and immediatly noticed my LED on the mixture gauge and the LED on the trim indicator smoke and are now non functioning. I shutdown all power and inspected but found no cause. I turned on the master and all instrument seemed ok except the two LED`s.I havent checked the voltage regulator but upon restart voltage is 14 but amps are at 30.
  Anyway I apologize for rambling, I have a few bugs to work out but I am anxious to get it set up correctly.I will also take a look at the Ross drive and get you some pics soon.
   Thanks again for your time and assistance.I feel much better about my investment based on your knowledge of the work that was done and despite a slew of malfunctions it will all come together soon.
Geir


There is a high buck Mazda rotary engine powered helicoptor project at Arlington
south side of the field in the industrial area.
Richard Martin on here is the test pilot. He can provide help.
Also Hayes Rotary Engineering in Redmond can also help with the engine
if you need it. http://www.hayesrotary.com/

Paul Lamar




The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.


Front-View.jpg

Richard-and-final-drive.jpg

Engine.jpg