>>>>
>>>> Paul
>>>>
>>>> Does anyone out there have a picture of the six port arrangement
under
>>>> the manifold? All I can find on the web is the four port. Are the
>>>> four
>>>> outer ports all the same size or are the lower auxiliary ones
smaller,
>>>> and if so what are each of the sizes? In the picture of the
>>>> previously
>>>> posted cut down manifold it looks like the upper ports are much
bigger
>>>> than the bottom ones.
>>>>
>>>> Tony Beaton
>>>>
>>>> The large round top holes in the end housing is the reason the
>>>> RX8 high power engine can generated 240 HP.
>>>>
>>>> Paul Lamar
>>
>
> Hi Paul,
>
> P Port Renesis? Wouldn't that defeat the purpose of why the Renesis was
> designed; namely eliminating port opening overlap and having side
> ports that
> supposedly provide a more homogeneous fuel/air distribution? If the
> engine
> could be created with no port overlap (more horizontal than round type
of
> port) then the concept would be worthy to explore.
>
> Doug in Japan.
>
> The main reason for eliminating the port over lap is
> low speed emissions and idle smoothness (about the same thing). At
> high speed
> you won't notice a difference in those regards except the engine
> will breathe a lot better with a p-port intake and therefore generated
> more power. You will still recycle the unburned fuel so
> BSFC will be slightly improved over a peripheral exhaust port.
>
> Paul Lamar
Ok, how about a hybrid, take a 4 port Renesis (Automatic version ), P-port
the housing, but, use the side port intakes with injectors at low RPM and
have the two extra P-ports join in at half throttle, no injectors as is done
on the regular 6 port Renesis. Might get you your smooth idle and full
blast at higher RPM.
Tony Beaton
Sure that will work but a P-port with slide throttle near the
rotor housing does not idle all that bad making this approach
not worth the trouble for an A/C. BTW you need four injectors for dynamic range
purposes. Tracy Crook supports four injectors anyway.
Two at low power and four at hi power.
I think this is a great idea for a street car however and Mazda
should do it.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.