Subject: Fear and loathing of the (12a)
From: Rotary Engine
Date: 5/16/2005, 8:54 PM
To: AA-me


    Everyone,

    I have been given the opportunity to have a 12a engine.  So,
    will it
    work in place of a 13b ?  Normally aspirated, what horsepower
    will it
    make ?  Will the PSRU's etc., bolt up to it ?  What should I
    expect

    or

    should I look for a 13b ?  Ignition, intake, exhaust, cooling,
    etc.
          Kevin

The 12A parts are all available through the same sources that supply 13B
parts including any Mazda dealer.

Both the 12A and 13B will turn the same RPM in aircraft use. The
housings and rotors of the 13B are 10 MM longer and produce a bit more
displacement and a bit more HP than a 12A.
The 12A has not been in US imported cars for years but this is true of
early 13Bs and parts for them are also available. If the engine is real
cheap or in real good condition I would buy it.

The irons and distributor are usable on a 13B. It would be a great
training aid even if you never build it for an airplane installation. A
few engines from the core pile at a junk yard will usually generate
enough good parts to build a nice engine, for very little money.

Lynn E. Hanover

The picture is from the SCCA national championships last fall. A 12A
powered RX-7 was on the pole and led the race until punted off by the
winning Toyota on the last lap. Yes, they will cheat to win.

This one is 280 HP at 10,000 + RPM. The owner would not say how much
over 10,000.



-- 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.


280HP12Aweb.jpg