Subject: Pressure Pickups - WAS: more cooling success
From: Rotary Engine
Date: 5/16/2005, 1:02 PM
To: AA-me


Good work Kent. Keep it up. Please get a chunk of kitchen foam and hot
glue it to the end of a  few tubes and measure some pressures ...

Paul Lamar

Paul (and group) -

Is there a better way to read pressure than gluing a block of foam to
the end of the tube?  It seems that this would rattle around a bit in
high speed airflow.

How about drilling multiple *small* holes in the tube, through-and-
through, at various angles, and plug the tube end.  Mounting the tube to
the radiator face and backside will give readings directly across the
rad.

Just another idea ...

---------------------------------------------
|****|      .  .  .  .      To
|Plug|    .  .  .  .  .     manometer -->
|****|      .  .  .  .
---------------------------------------------

-- 
Thanks,
-Vince Orton

Sure that will work fine but what we usually do is hold the tube and
foam in place with a bit of safety wire through the core.

When you try the foam trick you will be amazed how easy it is.

Paul Lamar

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.