Subject: ACRE AD on Andair fuel selector valves.
From: Rotary Engine
Date: 5/21/2005, 8:45 PM
To: AA-me


    Last message was irrelevant because not possible but with respect to Nat
    Puffer's copyrights would you not expect we extend him the same courtesy
    that you demand of us with respect to your web site and this list's
    copyrights? Besides, you already ave the gist of it in your drawing
    minus the return lines. Many (including us) do not have the valve
    because it entails running fuel lines all over the cockpit and the
    return lines only make it worse. Modern EFI pumps make good valves, when
    shut off they do not flow and they do not backflow.

    ..Chrissi

    www.CozyGirrrl.com <http://www.cozygirrrl.com/>
    Cozy Mk-IV RG 13B-turbo
    Plans #957 Chapter? big pieces done, details, details

    WAIT A MINUTE!!!! What is "irrelevant because not possible"?
    Are you talking about this 3D?

    How are you using the pumps? What EXACTLY are you doing?
    Send some sort of sketch or a picture.

    Paul Lamar

==================================================
irrelevant because unless canard builders are willing to give up their
back seats the vertical sumps are not possible.
Our fuel schematic so far: http://www.cozygirrrl.com/chapter21d.htm
...Chrissi

www.CozyGirrrl.com <http://www.cozygirrrl.com/>
Cozy Mk-IV RG 13B-turbo
Plans #957 Chapter? big pieces done, details, details

They are possible behind the firewall.

Your system is complicated with an extra pump and transfer
electronics but it should work  under most conditions.
Using a third transfer pump is cheating :) Good think
you are transferring fuel on a regular basis. If the transfer
pump fails and you don't notice it you could be a a world
of hurt. Also it will reduce the time you have to get
to an airport if the alternator fails.

Where are the all important fuel tank vents?
What are the dimensions of the sump tank?
Is it under the back rest or under the rear passenger
seat.

The whole idea is not to return hot fuel to the sump tank.
That could cause vapor lock especially with  auto fuel.
That is one of the things we are trying to avoid. You are
between a rock and a hard spot here. If the tank is big
enough to dissipate the heat it might uncover the pickup
when fuel is low due to slips or uncoordinated turns.
You could add a fuel heat exchanger and blast tube.

A better thing to do with your system is put the return fuel
into one of the main tanks as your are transferring fuel on
a regular basis continuously.

You will need to rely on the electronics to transfer
fuel. Frankly I would rather have one simple mechanical
valve to change tanks when the fuel in one tank was depleted.
Keep it simple.

The tall dual sump tank scheme is immune to nose down,
slips and uncoordinated turn problems.

You need to lay this out in 3D to check what flows where
under gravity conditions.

Paul Lamar

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.