Subject: JD's fuel valve
From: Rotary Engine
Date: 5/22/2005, 4:00 PM
To: AA-me


   If I remember correctly, the fuel valve in JD's Long EZ was in a bad
   location AND very difficult to turn. I believe there was mention of
   a pair
   of pliers in the cockpit when he took delivery, that were to be used to
   switch tanks.

   Bob

========================================================
Bob is correct. The orignal valve was a cheap and poorly made piece of
farm hardware that used a brass spool in a brass barrel. The fuel would
wash the lubricant out of the valve and they would bind internally. It
had to be lubricated on a regular basis with a special fuel proof lube
that was so expensive that the only way to obtain it was through Burt.
As soon as a better valve was available almost everyone changed over,
this was not the case with JD's plane, the valve was extremely difficut
to turn and I believe the pliers were vise grips. The valve was all the
way back at the firewall and a long torque tube was used to turn the
valve. JD went flying with next to no fuel on board in the first place,
he had recently purchased he plane and it had been refinished, for the
most part he was unfamilliar with the aircraft. The valve was located in
an awkward position behind the pilots left shoulder. I do not remember
if the pliers were still attached when they recovered the plane from
Monterrey Bay.
...Chrissi

www.CozyGirrrl.com <http://www.cozygirrrl.com/>
Cozy Mk-IV RG 13B-turbo
Plans #957 Chapter? big pieces done, details, details

-- 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.