========================================================
Bob is correct. The orignal valve was a cheap and poorly made piece of
farm hardware that used a brass spool in a brass barrel. The fuel would
wash the lubricant out of the valve and they would bind internally. It
had to be lubricated on a regular basis with a special fuel proof lube
that was so expensive that the only way to obtain it was through Burt.
As soon as a better valve was available almost everyone changed over,
this was not the case with JD's plane, the valve was extremely difficut
to turn and I believe the pliers were vise grips. The valve was all the
way back at the firewall and a long torque tube was used to turn the
valve. JD went flying with next to no fuel on board in the first place,
he had recently purchased he plane and it had been refinished, for the
most part he was unfamilliar with the aircraft. The valve was located in
an awkward position behind the pilots left shoulder. I do not remember
if the pliers were still attached when they recovered the plane from
Monterrey Bay.
...Chrissi
www.CozyGirrrl.com <http://www.cozygirrrl.com/>
Cozy Mk-IV RG 13B-turbo
Plans #957 Chapter? big pieces done, details, details
[Herb Sanders] Chrissi, I know you would not be critical of someone using
non-AN parts on an airplane!!! 30 years ago when we all started building
EZs, we were all poor - even BURT. Most everyone used that $15 brass valve -
left/right/off. Later, better (more expensive) materials and valves became
available and most of us changed them. JD put his new plane in the shop for
a custom paint job that must have cost $$$$$. If he was having to use
vice-grips to turn the valve, he should have spent $200.00 and had someone
put in a new valve - or even put some gas in the plane before he went off to
buzz the golf buddies and the beach. I flew the first flight on that
airplane and it flew good / running a tank dry, focusing on the valve and
not on keeping it straight and level was the proplem.
The fuel gravity flowed from either the right or left tank/sump thru the
valve, into the suction of an elec fuel pump / engine driven mech pump/ to a
carb. There was no return fuel from any injection system to anywhere and I
do not see anything from the JD accident that relates to Paul Conners
accident. Herb
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.