Hi Paul,
Thank you for making the trip to investigate the accident. My
fuel system for the Limo EZ uses a triangular shaped sump tank behind the
back seat just below the wing tanks. Both tanks feed the sump through 2"
X 3" openings. I return fuel to the right tank. All tanks vented with the
wings using two vents for nose down parking. Pumps will be mounted on the
other side on the sump in the cut out area that you posted earlier.
Joe Berki
Limo EZ
Are the left and right tank vented straight up to the
top of the fuselage with both vents facing forward.?
If so that looks pretty good. Should work fine.
Under horizontal flight the tanks should equalize fuel level.
If not check one of the tank vents for blockage.
If one vent gets blocked (say by a airborne bug) unbalanced air
pressures could rapidly pump all the fuel over to the other tank
including part of the fuel in the sump.
Slowing down to 125 MPH or less the tanks will start to equalize
again. Perhaps a tank to tank vent line would obviate that situation.
In an uncoordinated turn or side slip fuel will rapidly flow
from the high tank to the low tank through the sump tank.
This could be a problem when levels are low. Depending
on the roll angle the fuel pickup in the sump tank could
become open. That is why tall and skinny is good for sump
tanks as opposed to wide and low.
BTW Avoid steep high G banks at low altitude. One scenario for a
Rutan pusher departure is a steep bank followed by a canard stall.
The nose drops and you pick up speed rapidly immediately accompanied
by a rapid loss in altitude. I think that is what happened to an
air show pilot that crashed a Berkut at Santa Paula a couple of years
ago.
Here is a company that makes check (flow in one direction only)
valves that could be useful in certain fuel system designs.
http://www.specialtymfg.com/check_valves_brass/810_check_valve/default.asp
They must be tested to insure they will open under very low fuel
heads or pressures.
Paul Lamar
Thanks Paul,
The vents for the tanks are routed like the Cozy. Left tank vent
lines are routed over the top of the curvature of the firewall and exit
downward behind the spar and in front of the cowl protruding into the air
stream. The tubes are cut at an angle to let air in. Right tank and sump
are routed the same but exit the opposite side. The loop established by
going over the top was to prevent leaking out the vent lines if the plane
is inverted on the ground. There are a total of 5 vent lines. I guess I
will be paranoid flying with low fuel as that seems to be the weak link. I
am looking forward to hear about the P port. It is very exciting to see
this kind of work.
Joe Berki
Limo EZ
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.