This system uses no transfer pump.
Fuel transfer is done by dynamic pressure build up
in the left tank. Note: the left tank vent faces forward to read dynamic
pressure and the right tank has no vent.
At 200 MPH dynamic pressure is about 100 pounds per square
foot or about .69 psi. Since fuel is 6 pounds per gallon one
cubic foot of fuel weighs about 49 pounds.
That exerts a pressure on the bottom of a 12 inch high tank of
.338 psi. In other words the head is one inch of fuel equals
.028 psi. So a pressure of .69 psi will pump fuel 25 inches
straight up. At 150 MPH dynamic pressure is half that
so it will pump the fuel into the right tanks as long
as it is not over 12 inches high or deep.
You fill both tanks for takeoff. You climb out and reach cruising
speed. At 150 MPH fuel is automatically transfered from the
left tank to the right tank on a continuous basis.
This is an highly experimental system so try it at your own risk.
You could put a low pressure pump in the transfer line to test
the system in a real airplane. No need to worry about leaving the
transfer pump switch on as it will never pump fuel overboard
through the vent line because there is no vent line on the right tank.
Paul Lamar
Watch out for a leaky gasket on the fill tank, could vent gas overboard.
Bill Schertz
KIS Cruiser # 4045
Good point Bill Might want to fill through the left tank with
a large size transfer hose.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.