Subject: Fuel System Design - w/3 WAY NO Solenoid
From: Rotary Engine
Date: 5/25/2005, 10:25 AM
To: AA-me



> Paul;
>
> You have focused on a critical problem; i.e. EFI fuel system with two fuel
> tanks .  At some risk to my reputation, may I offer an EFI Fuel System
> Design for consideration!
>
> The attached diagram features a 3 way NO (normally open) solenoid valve
> (5/8
> dia).  A switch in the cockpit selects the fuel tank and powers the pump
> for
> that tank.
>
> When the Right tank is selected, the Right pump is ON and the 3-way NO
> valve
> returns fuel to the Right tank.  When the Left tank is selected, the Left
> pump is ON and the solenoid valve closes to direct return fuel to the Left
> Tank.
>
> Panel LED's show which tank is selected. Fuel Level gages show the tank
> fuel
> levels.  A "flashing / bell" alarm signals a low tank.  A pressure gauge /
> alarm reports the status of the fuel feed to the engine.
>
> Note that:
>    - Its a simple, fail safe design - intuitive for all  pilots
>    - There are no fuel lines in the cockpit!
>    - The expensive multiple pipe line selector valve is not required!
>    - All active components may be mounted on the fire wall, and/or under
> the
> fuel tanks.
>    - There are no surge tanks - all flow is "From - To" the selected fuel
> tank
>    -  The fuel level in each tank can be easily managed by switching tanks
> as
> required.
>     - Dual pump redundancy is maintained - perhaps improved
>
> As further comment,
> 1.)  Each tank vent line shall first route from the top of the tank to the
> bottom of the fuselage and then to the top of the fuselage - so if the
> plane
> flips inverted, gas will not dribble out - don't ask me how I know!
>
> 2.) All fuel lines shall include a ground wire to a common point,
> including
> the fuel cap on the tank (particularly for fiber glass tanks).
>
> 3.)  Fuel lines in the engine compartment should be stainless steel, and
> fire sleeved.  Note the flex lines - as required.
>
> 4.) The Long EZ fuel tank has  built in baffles to minimize the movement
> of
> the fuel, such as when in a banked turn.  The design also includes a sump
> tank with screen.
>
> 5.) Fuel flow rate is computed by summing the EFI injector pulse width.
>
> 6.) Observe that the EFI pump flow rate is typically about 10 GPM.  This
> may
> quickly empty a surge tank, even with a large connecting line.    I have
> always worried about additional / separate fuel sump tank.
>
> Regards,
>
> Keith (Black Hat) Moore
> LEZ

Keith
You have described excactly the fuel system that I had in my RV6A. It worked
perfectly. I will be installing the same system in my new RV7.

Ian Beadle

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.

Keith and Ian,

Do you have a good source for a NO solenoid valve?  I want install one
in the oil line to my turbo to be used in case of another turbo
failure.  It will prevent loss of the engine oil out the exhaust and
allow continued flight if necessary.

Dave Leonard

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.