Subject: P-port - more still
From: Rotary Engine
Date: 5/25/2005, 8:42 PM
To: AA-me



Are there any flying Rotaries in Iowa ?


Kevin
Naples/Ottumwa


The peripheral port completely eliminates the 90 degree turn (as well as
permitting a significantly larger opening).  In a P-Ported engine, the
side ports are redundant, and thus are completely closed off.


Ok, I have all of that.  Now for the p-porting, where does a person get
the specifics
for the location and size of the ports to be used by the machinist  ?
And then, the associated intake stub, is that welded in place with the
flange ?
Or is that somehow attached to the engine in another way.  I cannot tell
from
the picture that you sent me Paul.

Is there a "How to Hot Rod Your Rotary Engine" book that would explain
most of
this ?  Or should I just hang out here............  Thanks again.

Kevin

I scaled the one I am working on now from this drawing.
The stubs are epoxied in with high temp epoxy. JB Weld
also works.

That is a good idea. About 30 years ago I wrote a couple
of chapters in How to Hot Rod your VW :)

Paul Lamar

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.