Are there any flying Rotaries in Iowa ?
Kevin
Naples/Ottumwa
Let's take even a further step back: A P-Port is a Peripheral Port --
meaning that the air intake is directly through the rotor housing, vs
the standard porting which is through the side / end housings. A common
task for early 12a and 13b users was to partially fill the side ports to
create a 'ramp' so that intake air would more efficiently fill the rotor
housing (vs the 90 degree turbulence of the un-modified side port.)
/1. So even though the port was somewhat smaller it worked better because
of the smoother flow ?
/
Correct.
The peripheral port completely eliminates the 90 degree turn (as well as
permitting a significantly larger opening). In a P-Ported engine, the
side ports are redundant, and thus are completely closed off.
/2. Closed off - is that optional ? Does the engine still idle and make
power
from zero to whatever ok ?
/
I would not exactly say it makes power from zero but it does idle.
BTW a 2000 RPM engine idle is 700 RPM at the prop.
Less turbulence = better breathing = more power in a normally aspirated
engine. The elimination of the butterfly valve in favor of a slide
throttle is another attempt to remove turbulence-inducing design
elements. The name of the game here is high power in a highly reliable
(aka, simple) configuration.
Turbo / Supercharging can achieve the same power levels -- at the cost
of complexity, weight, and additional failure modes. History on this
group has amply demonstrated that stock turbochargers fail under even
moderate amounts of boost when used continuously in an aviation
application. Over the last 2 years, we've seen several failures of
stock turbochargers in flight which caused high anxiety / pucker-factor,
but fortunately no fatalities. Better still, the builders involved we
able to share the post-mortem of the turbo chargers themselves which led
to interesting observations of the root cause(s) - as well as an
unexpected failure mode which greatly impacted engine rpm after a
failure. This has led to better design specs for 3rd party units which
are more likely to survive aviation use (for those desiring to go the
boosted route).
/3. What was the observation of the root cause of turbo failure ? What
about
supercharging failures, some or none, causes ?
A combination of over speed (RPM) and 1600 to 1800 F temperature.
4. Street porting. Is that similar in concept to porting a valved
head, i.e.,
take out material to make a larger hole and smooth it out while doing it ?
Or is it more complex to a Rotary ? Thanks Kevin
/
[snip]
Yes. Probably more labor intensive than a p-port. Certainly the p-port
manifold would be cheaper than a street port manifold.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.