Subject: More progress on p-port
From: Rotary Engine
Date: 5/26/2005, 3:24 PM
To: AA-me


The long pipes will give us a base line HP curve.
We will then shorten the pipes an inch or so at a
time
and run new HP curves.

Paul Lamar

How are you going to get a stable manifold pressure
reading? With the small volume between the two rotors
and the throttle plate and the you are going to "see"
large differences in partial pressure (ie. vacuum)
when your throttle is closed.

Erik

Good question and I queried Tracy on the speed of response
of the pressure sensors. A lot depends on his software. If the
pressure sensors have a high speed response then samples could
be taken using the software and then average them.

I think we will find out in the next day or two.
We have a linear O2 mixture monitor so we will check for mixture readings
jumping around. We could also put a scoop on the pressure sensor
output but I don't see us doing that unless there is an
obvious problem. We could also monitor the injector pulse
width with a scoop to see if it is jittering.

BTW I also think it is highly configuration sensitive. If the pressure
lines are too long some sort of resonant condition could be set up.
It is also conceivable that a surge tank may be required.

Paul Lamar


The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.