Subject: Redesign dual injector holders
From: Rotary Engine
Date: 5/26/2005, 8:31 PM
To: AA-me

This addresses a few issues of welding on the injector
holders and drilling out the tube. That process has been eliminated.
this is much easier to weld to the end of the tube instead
of on top.

The bell mouth has also been incorporated. I will probably make that
larger in the final design.  It also allows the larger GM injector
connectors room to stagger. One up and one down. Consequently
a simple bar stock fuel rail can still be used.

Isn't hind sight a wonderful thing? :)

Before and after 3D's

Paul Lamar


It looks like you retained the staggered plugs (top, then bottom).  I
thought that was done on the prototype because the injectors used have
bigger plugs than anticipated.  Is there another reason to have the plugs
staggered?

The new design is a pretty big hunk of Al.  It's probably possible to mill
some of that away?


Regards,

Matt-

I think you mean the connectors to be precise. The Mazdatrix guys tell
me the old narrow GM connectors are no longer available. I need two injectors
side by side that are parallel to each other to simplify the fuel rail.
These injectors must be as close together as possible. Therein
the lies the reason for one connector up and one connector down.

Paul Lamar

Here is the final design with the larger radius. Yes you could mill
more away with additional mill set ups. The extra size is more than made
up for by the ease of getting it to work. IMHO the previous
design was just not practical. A casting would be wonderful
and perhaps some day when P-ports are widely used it will
be economical to make a casting. Also the shower approach Jerry Hey
is taking, if it works, eliminates this part. I just wanted
to be a bit more conservative on someone else's engine. Hence
this way of doing it.

If anybody needs dimensions let me know.

Paul Lamar

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.