This addresses a few issues of welding on the injector
holders and drilling out the tube. That process has been eliminated.
this is much easier to weld to the end of the tube instead
of on top.
The bell mouth has also been incorporated. I will probably make that
larger in the final design. It also allows the larger GM injector
connectors room to stagger. One up and one down. Consequently
a simple bar stock fuel rail can still be used.
Isn't hind sight a wonderful thing? :)
Before and after 3D's
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.