This addresses a few issues of welding on the injector
holders and drilling out the tube. That process has been eliminated.
this is much easier to weld to the end of the tube instead
of on top.
The bell mouth has also been incorporated. I will probably make that
larger in the final design. It also allows the larger GM injector
connectors room to stagger. One up and one down. Consequently
a simple bar stock fuel rail can still be used.
Isn't hind sight a wonderful thing? :)
Before and after 3D's
Paul Lamar
It looks like you retained the staggered plugs (top, then bottom). I
thought that was done on the prototype because the injectors used have
bigger plugs than anticipated. Is there another reason to have the
plugs staggered?
The new design is a pretty big hunk of Al. It's probably possible to
mill some of that away?
Regards,
Matt-
I think you mean the connectors to be precise. The Mazdatrix guys tell
me the old narrow GM connectors are no longer available. I need two
injectors side by side that are parallel to each other to simplify the
fuel rail. These injectors must be as close together as possible.
Therein
the lies the reason for one connector up and one connector down.
Paul Lamar
Connectors - yes..
Why is it important to have the injectors close to each other?
Matt-
They both shoot down the same two inch tube. You can put them anywhere
but the fuel plumbing becomes a nightmare with more chances
of leaking.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.