Well we got it all set up. Tried to start it and fuel poured
out of all four injectors. Injectors full on all of the time.
No spark. Flodded the engine.  37 pin D submin connector wired
backwards. Way too easy to do. I got  on Tracy case years ago about
this connector. More about that soon. Hopefully we did not
fry Tracy's computer. Will know more about that on Sunday
night when Tracy gets back from a flyin.

BTW if you are building a slide throttle seal it well
around the bottom. You want the fuel to flow into
the engine and not out between the plates. I'll
makes some changes in the drawings to make this easier.

Does anybody know of a good fuel sealant to use between
the plates of the slide throttle?

Paul Lamar

I have been using the polyurethane glue used to install windshields for
years to seal fuel tanks. can be found at paint shops or auto glass
shops. Very inert to both auto and av gas.
But  watch the temperature. It is not a high temp resistant product.
smale@ncinternet.net


The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.