Subject: 37 pin D submin
From: Rotary Engine
Date: 5/29/2005, 4:50 AM
To: AA-me

> > >>         Well we got it all set up. Tried to start it and fuel poured
> >>         out of all four injectors. Injectors full on all of the time.
> >>         No spark. Flooded the engine. 37 pin D submin connector wired
> >>         backwards. Way too easy to do. I got on Tracy case years ago > >> about
> >>         this connector. More about that soon. Hopefully we did not
> >>         fry Tracy's computer. Will know more about that on Sunday
> >>         night when Tracy gets back from a flyin.


> Paul
> About the 37 pin D submin, rather than introduce potential other
> problems, i.e., more parts and the chance of a poor connection under a
> screw head along with corrosion there (ask me about this) wouldn't it be
> easier to use a 37 pin con with removable pins ?  Just solder the wire
> to the pins and then insert them.  No miss matches, a better solder
> joint using a pin holding device (alligator clip) and the ability to
> swap pin locations if needed.  A step forward, not back ??
> Kevin
> > That is probably easier but now you are only half done. The wires come out
> of the 37 pin D submin in a random fashion while what you would like
> to have is say the four coils on the first four pins, the four injectors
>   on the next four pins and so on and so on. I can understand why Tracy
> designed it as he did in what appears to be a random fashion due
> to the limitations of his computer PC board layout.
> > Basically it is a rats nest. Hard to trace and hard to trouble shoot.
> The aux or secondary PC board will organize the wires into a logical
> grouping.
> > An alternate way of doing it is layout a wire harness jig on
> a large piece of plywood and bundle everything together.
> That is the way it is done in cars. Takes extra time
> to design and layout the jig.
> > BTW Mark do you have a PC board layout program?
> > Paul Lamar
> >

Hi Paul,

I've been thinking about offering a service of pre-wiring EC2 cables.
I have over 40 years experience in the electronics field, so soldering
and cabling aren't challenging tasks for me.  Besides making the first
cable is a lot more work than subsequent ones.  I have the prototype
finished but need to go to the airport right now, so I will send some
photos tonight or tomorrow.

Too bad I didn't start a couple of weeks earlier.  I would have been
glad to donate a cable for your testing.

Bob W.


-- 
http://www.bob-white.com
N93BD - Rotary Powered BD-4 (real soon)

Im sorry too Bob :)

What do you think of the idea for the aux secondary PC board?

Paul Lamar


I think it looks like a good option.  It also eliminates the backshell
sticking out.  It probably should have a cover to protect the exposed
contacts, add some holes at each end of the DC37 connector to allow
screwing the board to the EC2 using the DC37 mounting posts, and
provide some method of strain relief for the cables.

Bob W.

(Cable photo's tomorrow.  I have them, but it's too late to mess around
on the computer.)



-- 
http://www.bob-white.com
N93BD - Rotary Powered BD-4 (real soon)


-- 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.